Sign In

These are the OXVA pods and cartridges stocked on the store, five items covering the XLIM, NeXLIM, Oneo and VPrime platforms. OXVA builds the coil into the cartridge, so you replace the whole pod rather than fitting a separate coil. Resistances run from 0.2ohm up to 1.2ohm, which covers everything from a tight mouth to lung pull to a sub-ohm draw on OXVA pod kits.

What's in this range

Five cartridges cover the four OXVA platforms carried here.

• XLIM replacement cartridge, 3ml, in 0.4ohm, 0.6ohm, 0.8ohm and 1.2ohm, the widest range in this listing.
• XLIM Pro replacement pod, 2ml, in 0.4ohm, 0.6ohm and 0.8ohm.
• NeXLIM replacement cartridge, 4ml, in 0.6ohm, 0.8ohm and 1.2ohm, using OXVA's dual mesh system.
• Oneo replacement pods, 3.5ml, sold as a pack of three in 0.4ohm, 0.6ohm and 0.8ohm.
• VPrime replacement cartridge, 5ml, in 0.2ohm and 0.4ohm, the largest capacity and lowest resistance here.

How to choose

Start with the platform, because XLIM, XLIM Pro, NeXLIM, Oneo and VPrime cartridges are not interchangeable even though they all say OXVA on the box. Then pick resistance by how you draw. A 1.2ohm cartridge is the tightest, lasts longest and pairs with 35mg or 50mg nic salt. A 0.8ohm sits in the middle and suits 25mg to 35mg. A 0.4ohm or 0.6ohm cartridge opens into a restricted lung draw with far more vapour, so drop to 20mg salt or use a 3mg freebase. The 0.2ohm VPrime is a sub-ohm cartridge and should only see low strength freebase. OXVA publishes a wattage band for the NeXLIM resistances, roughly 10W to 13W for 1.2ohm and up to 40W for 0.6ohm, which is a useful guide for any of these. Pods also have their own page at OXVA replacement pods, the XLIM and NeXLIM kits are at OXVA XLIM pod kits, and all spares are in vape accessories, coils and pods.

Frequently Asked Questions

Do XLIM and NeXLIM cartridges fit the same device?

No. XLIM, XLIM Pro, NeXLIM, Oneo and VPrime are separate cartridge platforms. Check which one your kit takes before ordering.

Do OXVA cartridges have the coil built in?

Yes. OXVA pods come with the coil inside, so you replace the whole cartridge rather than fitting a separate coil.

What wattage should I run each resistance at?

OXVA lists roughly 10W to 13W for a 1.2ohm cartridge, 14W to 18W for 0.8ohm and up to around 40W for 0.6ohm in boost mode. Use those as a starting point.

Which resistance works with 50mg nic salt?

The 1.2ohm cartridges. At 0.6ohm or below the vapour output is high enough that 50mg becomes uncomfortable, so drop to 20mg or use freebase.

How many pods come in a pack?

Most are sold individually. The Oneo replacement pods are the exception and come as a pack of three.